Jabiruyank
Jabiruyank
@jabiruyank
Estimable Member
Joined: Aug 22, 2020
Last seen: Apr 8, 2024
Topics: 22 / Replies: 42
Reply
RE: Piston Rings 2200A Gen 1

Greetings Jabsupport. Rodger that, 25 hours with straight mineral oil. Is there a specific procedure I should follow on first start? Jabiru recommends...

2 weeks ago
Reply
RE: Cylinders #2 & 4 Run Hot EGT & CHT - 2200A

@jabiru-support Thanks for the quick reply! Is this criss cross commercially available? Is there any documentation by Jabiru covering this?

1 month ago
Reply
RE: Magneto Stays Hot When Ambient Temp Is High

Update 02/27/24. With cooler temperatures, this has not occurred. During the summer months, (this was originally posted last April) I changed the mag ...

2 months ago
Reply
RE: Cold start jetting

@wyomingeuropa Was Bing support from Bing Agency? Bing Carburetor Home - BING AGENCY INTERNATIONALSOLE DISTRIBUTORFOR BING CARBURETORS AND THROTTLE B...

1 year ago
Reply
RE: Jabiru Scimitar Propeller Damage

Greetings Jab support, i just realized ai posted a propeller issue on the airframe topic! Sorry. To answer your question, the affected area does not...

2 years ago
Reply
RE: Hole in Jab Scimitar Propeller

I just realized this is posted in the wrong topic and should be in "Propellers"

3 years ago
Reply
RE: Vibration!!

Greetings Jab support, During balancing of the propeller which included applying enamel paint and sanding off excess weight, I encountered the attac...

3 years ago
Reply
RE: Vibration!!

Greetings Jab support, Arion aircraft has located a used prop flange and crank so I can perform the static balance of the scimitar propeller. The ma...

3 years ago
Reply
RE: Vibration!!

Yes, it did. I changed it as I was only getting 2750 RPM WOT. It was an error on my part as I had the pitch set at 21 degrees. The vibration occurred ...

3 years ago
Reply
RE: Vibration!!

Thanks for the quick reply. Yes, I checked both blades’ pitch. They’re within .1 degrees. Tracking was checked as well and it is at 2mm. Machining a b...

3 years ago
Reply
RE: Jet Sizing

@jabiru-support To use your expression, crikey! The soot accumulation using the 290 with a 235 was super thick in the exhaust pipes! This occurred a...

3 years ago
Reply
RE: Mag Filters For My 2200

@jhmcglynn When I bought the plane, the Garmin SL 40 was inop and I purchased a drop in replacement, Icom A210. I’ve read where some com radios are ...

3 years ago
Reply
RE: Jet Sizing

Hello Jab support, I installed a new mechanical fuel pump, and it looked as if the issue was resolved but the following day, it was doing the same t...

3 years ago
Reply
RE: Jet Sizing

Hello Jab support, I changed the needle back to the original Bing and I still had the same problem; the engine cuts off when I applied more throttle...

3 years ago
Reply
RE: Jet Sizing

Greetings Jab support. I just received 4A138BOD. The Jab is much shorter than the original Bing needle on the CV94 carburetor? Is that correct? See at...

3 years ago
Page 1 / 3