Notifications
Clear all
How To Use This Forum: FAQ
4
Posts
3
Users
1
Likes
3,681
Views
Topic starter
09/11/2021 10:59 pm
I changed a CHT probe yesterday and ran the engine. All was well. Today I cowled the plane up and went to fly. Tach is inop. Reads zero and does not move. Both mags work fine. I have the ignition booster installed so when I check the left mag the tach goes to zero normally (well shows about 10 rpm). I looked for loose or broken wires and everything seems fine. I assume the tach sensor is the small three wire unit at the top of the flywheel.
Everything worked yesterday and all I did was cowl the airplane. I'm at a loss.
Elizabeth121 reacted
09/11/2021 11:19 pm
Hello,
I am guessing that you are taking you tacho signal from the coils somehow? Can you attach a picture of this tach sender unit, as I don't think I am understanding properly?
Topic starter
12/11/2021 8:27 pm
