Olav Soendergaard Poulsen
@olpo
Eminent Member
Joined: Aug 8, 2018
Last seen: Aug 6, 2024
Topics: 8 / Replies: 20
Reply
RE: Breather bottle with oil return line.

Thanks Doug. And appologies. I took it for granted it is a US quart referred to. When changing oil my engine will not take much more than 2 US quarts,...

6 years ago
Reply
RE: Breather bottle with oil return line.

By the way. Jabiru writes in various documents that the oil volume of a J2200 is 2.1 liter or 2.0 quarts. Must be opposite since one quart is only 0.9...

6 years ago
Topic
Replies: 3
Views: 2395
Reply
RE: EGT sensor position

Hi Doug. I have finished tuning my carburetor so it now has got the version 5 needle and a 2.90 needle jet. Main jet is 2.55. Consumption at 2800 rpm ...

6 years ago
Reply
RE: 2200 oil leaks

Hi Doug. Replaced the o-ring for the dip stick tube, and it seems to have stopped the leak. The old o-ring was flat on the inside after sitting there ...

6 years ago
Reply
RE: 2200 oil leaks

Thanks. I will check the o-ring and replace it if needed. Can you confirm the size of it? 18.72x2.62mm. About the leak between the crankcase halves. T...

6 years ago
Reply
RE: 2200 oil leaks

My engine is leaking small amount of oil from the area where the oil dipstick tube is attached to the sump. I am pretty sure the leak is not comming f...

6 years ago
Topic
Replies: 3
Views: 3460
Reply
RE: Carburetor settings at delivery from your workshop

Thanks Doug. I hope soon to have a chance to do a flight test with reduced mixture. I will keep you posted on which settings I end up with. Regards Ol...

6 years ago
Reply
RE: Carburetor settings at delivery from your workshop

This is the needle I have got. Can you confirm it is the 4A138AOD-1 needle? Regards Olav IMG_20180811_120608.jpg

6 years ago
Topic
Replies: 1
Views: 3438
Reply
RE: Carburetor settings at delivery from your workshop

Hi again. Just had a closer look at my carburetor. It appears that what probably is the original settings are engraved on the carburetor. It says M225...

6 years ago
Reply
RE: Carburetor settings at delivery from your workshop

Hi Jabiru. Coming back to this issue. I was not able to log in on my original account, and when asking for a new password I was told the account did n...

6 years ago
Page 2 / 2